IBM 8668 - Eserver xSeries 232, Hardware Maintenance Manual

Page: 88 / 182

Installing the bezel and front door
Note: The illustrations in this document might differ slightly from your hardware.
Bezel
Flange
Door
To install the bezel:
1.
Place the tabs at the bottom edge of the bezel in the slots at the bottom front of
the server.
2. Press the top of the bezel toward the server until it clicks into place.
To install the server door:
1. Set the door on the bottom hinge.
2. Press the flange downward while pressing the top of the door toward the
server, until the flange connects with the top hinge. Then, release the flange.
3. Close and lock the server door.
Attention: Be sure to maintain a clearance of at least 127 mm (5 inches) on
the front and rear of the server to allow for air circulation.
Installing the cover
80
Hardware Maintenance Manual: Type 8668