IBM 8668 - Eserver xSeries 232, Hardware Maintenance Manual

Page: 53 / 182

DANGER
Electrical current from power, telephone, and communication cables is
hazardous. To avoid a shock hazard:
v
Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical
storm.
v
Connect all power cords to a properly wired and grounded electrical
outlet.
v
Connect to properly wired outlets any equipment that will be attached
to this product.
v
When possible, use one hand only to connect or disconnect signal
cables.
v
Never turn on any equipment when there is evidence of fire, water, or
structural damage.
v
Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
v
Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached
devices.
To connect:
a.
Turn everything OFF.
b.
First, attach all cables to devices.
c. Attach signal cables to connectors.
d. Attach power cords to outlet.
e. Turn device ON.
To disconnect:
a.
Turn everything OFF.
b.
First, remove power cords from outlet.
c. Remove signal cables from connectors.
d. Remove all cables from devices.
v
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The
device also might have more than one power cord. To remove all electrical
current from the device, ensure that all power cords are disconnected from
the power source.
1
2
3. Release the left and right side latches and pull the server out of the rack
enclosure until both slide rails lock.
Removing the cover (rack model)
Installing options
45