IBM 8647 - Eserver xSeries 225, Installation Manual

Page: 32 / 112

Removing the bezel
When working with some devices, such as additional optical drives, you must first
remove the bezel to access the device.
Complete the following steps to remove the bezel:
1. Remove the side cover (see “Removing the side cover” on page 11).
2. For hot-swap hard disk drive models:
a. Open the server door.
b. Rotate the hot-swap lock bar forward and remove it from the bezel (see the
illustration on page 26). If the hot-swap lock bar will not rotate, press the top
of the hot-swap lock bar to release the lock mechanism.
3. Locate the bezel-release lever; then, press the bezel-release lever toward the
front of the server.
4. Pull the top of the bezel away from the chassis; then, push the bezel down to
disengage the bottom tabs.
5. Remove the bezel from the server and store the bezel in a safe place.
For instructions for replacing the bezel, see “Replacing the bezel” on page 34.
12
IBM xSeries 225 Type 8647: Installation Guide