IBM 8248-L4T, Manual

Page: 95 / 214

Removing or installing a disk drive bezel
Learn how to remove or install the disk drive bezel from and into a disk drive.
Removing a disk drive bezel from a disk drive or filler
Learn how to remove a disk drive bezel from a disk drive or a disk drive filler.
Learn to remove the disk drive bezel from either a failed disk drive that had a bezel installed in it or
from the disk drive filler in the slot where you are replacing the failed disk drive. The removed disk
drive bezel must be attached in the replacement disk drive or a disk drive filler before installing the disk
drive or filler in the system or expansion unit. To install a disk drive filler, see “Installing a disk drive
bezel in a disk drive or filler” on page 80. Perform the steps in this procedure only if the disk drive or
the disk drive filler has a disk drive bezel attached to it.
Important: If the disk drive bezel does not have a thumbscrew, it is not removable and is a SAS disk
drive.
Note: Some of the figures in this procedure might not look exactly like the system or expansion unit that
you have. However, the steps to perform the task are the same.
1. From the removed disk drive or disk drive filler, gently pull off the disk drive bezel latch (A) from
the front of the filler, as shown in Figure 48 on page 80.
2.
Loosen and then pull out on the thumbscrew (C) to release the bezel (B) from the front edge of the
filler.
© Copyright IBM Corp. 2013
79