IBM 8248-L4T, Manual

Page: 31 / 214

3. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, then press Enter.
4.
When the identify LED flashes, slide the solid-state drive into the EDR1 PCIe storage enclosure until
the drive stops.
Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
EDR1 PCIe storage enclosure.
5. Rotate the handle (A) to the locked position.
6. Install the bezel (B) .
7. On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for verifying the disk drive or solid-state drive installation. For instructions, go
to “Verifying that the new disk drive or solid-state drive is installed and operational.”
Verifying that the new disk drive or solid-state drive is installed and
operational
Press Enter on the Complete Device Concurrent Add display to indicate that the disk drive or solid-state
drive is installed. The identify LED turns off.
Complete the following steps to verify that the new disk drive or solid-state drive is operational:
1. Log in as root user.
2. Type iprconfig on the command line of the Linux session and press Enter . The IBM Power RAID
Configuration Utility display is shown.
3. Select Display hardware status . The Display Hardware Status display is shown, similar to the
following figure.
Figure 7. Installing a solid-state drive in the EDR1 PCIe storage enclosure
Installing a disk drive or solid-state drive
15