IBM 8248-L4T, Manual, Page: 84 / 214

6. In the Hardware Service Manager (HSM) display, select the drive that you want to replace.
7.
Press Enter on the console.
Important: When you press Enter, after your selected time delay, the service indicator light comes on
(solid) for 18 seconds. You then have 18 seconds to slide the drive all the way in and then lock it in
place by pushing in the drive handle. You can set an appropriate time delay of 01 - 19 minutes to
allow adequate time to access the disk drive or solid-state drive.
8. When the identify LED turns on solid, slide the disk drive or solid-state drive all the way into the
system or an expansion unit, and push the drive handle
(A) in until it locks, as shown in Figure 42.
9. On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for completing the disk drive or solid-state drive replacement. For instructions,
see “Completing the disk drive or solid-state drive replacement by using the HSM.”
Completing the disk drive or solid-state drive replacement by using
the HSM
Complete the following task to complete the disk drive or solid-state drive replacement:
1. Return to the console and wait until the Concurrent Maintenance Results display is shown. Press
Enter.
2. If you return to the Service Action Log display, exit the service action log.
3. When the Hardware Service Manager display is shown, press F3 .
4. Select Non-configured disk units from the Work with Disk Units display, and press Enter.
5. Return to the console and wait until the Concurrent Maintenance Results display is shown, and
press Enter.
6. If you return to the Hardware Service Manager (HSM), exit the HSM.
Figure 42. Replacing a disk drive in the system
68
Disk drives or solid-state drives