IBM 7380E1U, Installation And User Manual

Page: 22 / 160

Features and specifications
The following information is a summary of the features and specifications of the
server. Depending on the server model, some features might not be available, or
some specifications might not apply.
Table 1. Features and specifications
Microprocessor:
v Intel Xeon up to six-core with integrated
memory controller and Quick Path
Interconnect (QPI) architecture
v Designed for LGA 1366 socket
v Scalable up to twelve cores
v 32 KB instruction cache, 32 KB data
cache, and 4MB, 8 MB and 12MB
cache that is shared among the cores
v Support for up to two microprocessors,
second microprocessor with pluggable
VRM
v Support for Intel Extended Memory 64
Technology (EM64T)
Note:
v
Do not install an Intel Xeon
™
5500
series microprocessor and an Xeon
™
5600 series microprocessor in the same
server.
v Use the Setup utility to determine the
type and speed of the microprocessors.
For a list of supported microprocessors,
see http://www.ibm.com/servers/eserver/
serverproven/compat/us/
.
Memory:
v Sixteen DIMM connectors (eight per
microprocessor)
v Minimum: 1 GB
Note: If you install a ServeRAID-M1015
SAS/SATA adapter, make sure at least
2 GB of memory is installed in the
server before you run DSA from a
bootable CD.
v Maximum: 192 GB
– 48 GB using unbuffered DIMMs
(UDIMMs)
– 192 GB using registered DIMMs
(RDIMMs)
v Type: Registered or unbuffered ECC
double-data-rate 3 (DDR3) 800, 1066,
and 1333 MHz DIMMs only
v
RDIMMs sizes: 1 GB, 2 GB , 4 GB , 8
GB, and 16 GB single-rank, dual-rank
or quad rank
v
UDIMMs sizes: 1 GB, 2 GB and, 4 GB
single-rank or dual-rank
v
Chipkill supported
Drives:
v SATA:
–
DVD (standard)
– DVD/CD-RW (optional)
– Maximum of two devices can be
installed
v Diskette (optional): External USB 1.44
MB
v Supported hard disk drives:
– Serial Attached SCSI (SAS)
Expansion bays:
v
Twenty-four 2.5-inch HDD bays (one
optical DVD drive)
Note:
– SAS expander card does not
support 3 GB RAID adapters.
– When using ServeRAID adapter
M1015 to support more than
sixteen 2.5-inch hard disk drives,
the maximum number of RAID
supported drives is 16. All the other
drives will remain JBOD (the drives
are presented to the operating
system without a RAID
configuration).
– If the server is configured for RAID
operation using a ServeRAID
adapter, you might have to
reconfigure your disk arrays after
you install drives. See the
ServeRAID adapter documentation
for additional information about
RAID operation and complete
instructions for using the
ServeRAID adapter.
v
Eight 3.5-inch HDD bays (only
supports UltraSlim DVD drive)
v
Three half-high 5.25-inch bays (one
DVD drive installed)
Note: Full-high devices such as an
optional tape drive will occupy two
half-high
5.25-inch bays.
PCI and PCI-X expansion slots:
v
Six PCI expansion slots on the system
board:
– Four PCI Express x8 (2x8 link, 2x4
link)
– One PCI Express x16 (x8 link)
– One PCI 32-bit
v
One or two expansion slots on the PCI
extender card:
– Standard - One PCI Express x8 (x4
link) on the PCI-Express extender
card
– Optional - Two PCI-X 64/133 slots
on the PCI-X extender card
Power supply:
Note:
To upgrade to two 920-watt hot-swap
power supplies, install the redundant power
and cooling option kit. The kit includes one
hot-swap 920-watt power-supply and three
hot-swap fans.
v
Standard: One 920-watt 110 V or 240 V
AC input dual-rated power supply
v Upgradeable to two 920-watt hot-swap
power supplies
Hot-swap fans:
v
Three (standard)
v
Upgradeable to six fans (for redundant
cooling)
Note: To upgrade to redundant cooling,
install the redundant power and cooling
option kit. The kit includes one 920-watt
hot-swap power-supply and three hot-swap
fans.
Size:
v Tower
– Height: 440 mm (17.3 in.)
– Depth: 767 mm (30.2 in.)
– Width: 218 mm (8.6 in.)
– Weight: approximately 38.9 kg (85.6
lb) when fully configured or 27.4 kg
(60.4 lb) minimum
v
Rack
– 5 U
– Height: 218 mm (8.6 in.)
– Depth: 702 mm (27.6 in.)
– Width: 424 mm (16.7 in.)
– Weight: approximately 37.2 kg (82 lb)
when fully configured or 26.2 kg (57.7
lb) minimum
Racks are marked in vertical increments of
4.45 cm (1.75 inches). Each increment is
referred to as a unit, or “U.” A 1-U-high
device is 4.45 cm (1.75 inches) tall.
6
IBM System x3500 M3 Type 7380: Installation and User’s Guide