![background image](http://html1.mh-extra.com/html/ibm/7208/7208_setup-and-operator-manual_3453419023.webp)
2.1.4 Step 4. Setting the SCSI Address
The SCSI address is a unique address that identifies the 7208 Tape Drive to your AS/400 system unit. Use the SCSI address switch to
set the SCSI address of the 7208 Tape Drive. The switch ( 1 in Figure 3) is located on the rear of the tape drive. Figure 3 also shows the
SCSI bus cable connectors 2 , the cooling fan 3 , and the power cable connector 4 .
Note:
The SCSI address switch must be set to 0 (or the 7208 Tape Drive will not operate as an installed device).
+------------------------------------------------------------------------+
¦ ¦
¦ ¦
¦ ¦
¦ ¦
¦ PICTURE 6 ¦
¦ ¦
¦ ¦
¦ ¦
¦ ¦
+------------------------------------------------------------------------+
Figure 3. Rear View of the 7208 Tape Drive
Make sure that the SCSI address switch is set to 0. To set the switch, press the + or -- pushbutton.
7208 Tape Drive Setup and Operator Guide
Step 4. Setting the SCSI Address
¦ Copyright IBM Corp. 1998
2.1.4 - 1