Replacing the drive power cable in the 7063-CR2 system
To replace the drive power cable in the IBM Power Systems HMC (7063-CR2) system, complete the steps
in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Using your labels, replace the drive power cable into the power distribution board and into the drive
holder.
Ensure that the cable latch clip snaps into place in the connector on the power distribution board.
Figure 2. Connecting the drive power cable
3. Install the service access cover.
For instructions, see “Installing the service access cover on a 7063-CR2 system” on page 105.
4. Replace the system in the rack and replace the components that you removed.
For instructions, see “Placing a 7063-CR2 system into the operating position” on page 103.
5. Power on the system for operation.
For instructions, see “Starting the 7063-CR2 system ” on page 98.
Removing and replacing a drive signal cable in the 7063-CR2
Learn how to remove and replace a drive signal cable in the IBM Power Systems HMC (7063-CR2) system.
4 Power Systems: Servicing the IBM Power Systems HMC (7063-CR2)
