IBM 6343, Hardware Maintenance Manual

Page: 53 / 230

Chapter 4. Installing Options
45
• If it is a hard disk drive, set as a slave device.
• If it is the first CD drive or DVD drive, set as a master device.
• If it is an additional CD drive or DVD drive, set as a slave device.
Refer to the documentation that comes with your drive for master/slave jumper
information.
7. Install the drive into the bay. Align the screw holes and insert the two screws.
8. Pivot the drive bay cage back into place.
9. Each integrated drive electronics (IDE) drive requires two cables; a four-wire
power cable that connects to the power supply and a signal cable that connects to
the system board.
The steps to connect an IDE drive are different depending on the type of drive you are
connecting. Locate the procedure below for your drive connection.
To connect the first IDE CD drive or DVD drive: 1.Locate the three-connector signal
cable that came with your computer or with the new drive.
2. Locate the secondary IDE connector on the system board. See “Identifying parts
on the system board” on page 39.