IBM 4851 514, Planning, Installation And Service Manual

Page: 95 / 162

Mounting foot- removal and replacement
Note: The base plate is not present when a mounting foot is used.
The mounting foot allows you to sit Model 514 on a cash drawer without an
integration tray.
1. Remove the base plate, see “Base plate - removal and replacement” on page
77.
2. Install the mounting foot.
Integrated customer display – removing and replacing
See “Installing the integrated customer display” on page 9 and reverse the
procedures to remove.
Cash drawer FRUs – removing and replacing
This section describes how to remove and replace both full-size and compact cash
drawer-related FRUs. It also contains removal and replacement procedures that are
common to both cash drawers.
Full-size cash drawer FRUs – removing and replacing
This section describes how to remove and replace full-size cash drawer-related
FRUs.
Removing and replacing a full-size drawer
To remove a full size cash drawer:
1. If the cash drawer is mounted to the underside of a counter, refer to the
instructions that came with the mounting brackets.
2. Switch OFF the power to the SurePOS 500 Model 514. Unplug the system
power cord from the external power source.
3. Open the cash-drawer rear cover.
4. Unplug the cable from the rear of the cash drawer.
Figure 65. Mounting foot
Removing and replacing FRUs
Updated October, 2008
Chapter 5. Removing and replacing FRUs
79