IBM 4002AC2, Installation And User Manual

Page: 58 / 82

Note: The latch may be attached to either the top or the bottom of the optical
module.
5. Grasp the latch and pull the fiber optic module out of the port.
6. Store the fiber optic module in a safe, static-free place or in an anti-static bag.
7. Install a new fiber optic module in the port. For information about performing this
task, refer to “Installing a new fiber optic module.”
Installing a new fiber optic module
You must install a fiber optic module (SFP+ or SFP transceiver) in each 10-Gigabit
Ethernet fiber port you want to use. You can install a new fiber optic module in a
port while the device is powered on and running.
To install a fiber optic module, you will need an ESD wrist strap with a plug for
connection to a metal surface.
CAUTION:
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm
resistor.
Complete the following steps to install a fiber optic module:
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a
metal surface (such as an equipment rack) to act as ground.
2. Remove the new module from its protective packaging.
3. Gently insert the fiber optic module into the port until the module clicks into
place. The module is keyed to prevent incorrect insertion.
Cabling a fiber optic module
Complete the following steps to cable a fiber optic module:
1. Remove the protective covering from the fiber-optic port connectors and store
the covering for future use.
2. Before cabling a fiber optic module, clean the cable connectors and the port
connectors thoroughly. Refer to “Installing a new fiber optic module.”
1
net_com008
Figure 12. Disconnecting a fiber optic module latch
net_com002
Figure 13. Removing a fiber optic module
32
IBM x-series of Ethernet Switches Installation and User Guide