Step 3. Setting the SCSI ID
Refer to the following diagram when setting the SCSI ID.
1
68-pin high density SCSI connector
2
Power connector
3
SCSI ID jumpers
Note:
1.
When setting the SCSI ID, use the jumpers that come with the tape drive.
2.
If your enclosure uses a remote SCSI ID switch, remove the jumpers from the
jumper pins on the tape drive and connect the remote switch.
1.
Find the jumper pin setting that corresponds to the SCSI ID number you
choose; then place jumper pins on the SCSI ID blocks as shown. You can
use a pair of flat-nose pliers to place the jumpers on the jumper pins.
1
SCSI ID
2
Jumper blocks
1-4
40/80 GB HH DLTVS Internal Tape Drive: User’s Guide
Summary of Contents for 40/80 GB HH DLTVS
Page 1: ...40 80 GB HH DLTVS Internal Tape Drive User s Guide OPTIONS by IBM...
Page 4: ...iv 40 80 GB HH DLTVS Internal Tape Drive User s Guide...
Page 28: ...2 6 40 80 GB HH DLTVS Internal Tape Drive User s Guide...
Page 30: ...A 2 40 80 GB HH DLTVS Internal Tape Drive User s Guide...
