IBM 3160, Introduction And Planning Manual

Page: 34 / 102

Dimension A Values:
Dimension A Configuration
65 cm (25.6 in.) Base printer without side stacker and 2000-sheet tray
40.5 cm (15.9 in.) Add to base printer for side stacker with short paper
50.2 cm (19.8 in.) Add to base printer for side stacker with long paper (A3 and
Ledger)
46 cm (18 in.) Add to base printer for optional 2000-sheet tray
70.2 cm (27.6 in.) Add to base printer for 3000-sheet side stacker (option).
This dimension includes 6 inches of travel when stacker is
pulled away from printer to remove paper jams.
Dimension B Values:
Dimension B Model
69.5 cm (27.4 in.) 3160-001
77 cm (30.3 in.) InfoPrint 60
Installation Requirements
Procedures for installing the printer are included with the printer and in the IBM
InfoPrint 60; 3160 Advanced Function Printer: Maintenance Information, 30H7534.
Although a service person installs the printer, the customer is responsible for the
following pre-installation tasks:
Ÿ
Make sure the environmental, electrical, and space requirements specified in
this chapter are met. Use the “Installation Planning Worksheet” on page 21 to
complete this step.
Ÿ
Make sure the receiving area and internal delivery route contain no obstacles
that might interfere with moving the printer to its planned location:
– Halls and doorways must be large enough for the printer to pass through,
and corners and angles must be large enough to permit the printer to turn.
For example, the minimum doorway opening through which this printer can
pass from a 91.5 cm (36 in.) wide aisle is 75 cm (30 in.).
– Ramps must have no more than 12 degrees, 50 minutes incline to allow
clearance for the lower edge of the printer with its supporting feet retracted.
– Elevators and elevator doorways must be able to accommodate the size
and weight of the printer and the people who are moving it.
– Stairs, sills, and gaps, and carpeting can make rolling the printer difficult.
Ÿ
Do not tilt the printer more than 15°.
Ÿ
Make sure that the floor is level within
±
1.5° from earth horizontal in any plane.
Ÿ
Make sure that an approved electrical outlet with correct power is reserved for
the printer (and another for the 3000-sheet stacker (option), if appropriate), and
that it can be reached with the power cable.
Ÿ
If the printer is being installed in an area with a raised floor, make sure the
access hole in the raised floor is large enough for both the communication
attachment cables and the power cable.
20
InfoPrint 60 and 3160 Introduction and Planning Guide