IBM 3160, Introduction And Planning Manual

Page: 33 / 102

Physical Layout and Space Requirements
Figure 2 shows the space requirements for a permanent installation.
As you plan your physical layout:
Ÿ
Install the printer away from the main traffic pattern. Allow space for key
operators and customer engineers to perform their tasks. This space should
not extend into walkways.
Ÿ
Install the printer in a location that is convenient for the key operator and other
users. For example, consider whether the planned location is close to printer
supply storage areas and to output distribution areas.
Ÿ
Allow 2.1 meters (83 in.) between the floor and the lowest permanently
attached object above the printer, such as a light or a cable rail. This layout
gives printer operators and customer engineers space in which to work.
Ÿ
Check the route that the printer must travel from your loading dock to the
location where it will be installed, to ensure that it fits through the doorways and
halls. When possible, move the printer from the dock to its installation location
on its shipping pallet.
Note: Install the printer permanently in the service position if you attach it to a
System/370 parallel channel (available only with 3160-001).
Figure 2. Service Clearances
Chapter 4. Preparing the Physical Environment
19