IBM 2145-4F2, Installation Manual

Page: 91 / 143

c.
Remove the two bolts
1
and additional nut
2
on the left side of the
bracket, as seen in Figure 38. Next, remove the battery retaining bracket
3
.
1
Bolts
2
Nut
3
Battery retaining bracket
d. Grip the tab on the front of the battery and pull the battery forward until
it can be accessed by two service representatives.
e.
With the assistance of another service representative, lift the battery
assembly clear of the 2145 UPS and place to one side.
Note: The front cover for the 2145 UPS is not installed, however, it is
included inside of the shipping carton. The front cover is installed
later in the installation process.
2. With the assistance of another service representative, lift the 2145 UPS clear of
the shipping carton and place it on a flat, stable surface.
3. Remove the two screws
1
(Figure 39 on page 62).
4.
Pull the electronics assembly
2
out of the 2145 UPS, and put it to one side.
1
2
3
Figure 38. Removing the battery retaining bracket
Chapter 4. Installing the UPS, the master console, and the SAN Volume Controller
61