2. Before opening the static-protective bag containing the tape drive,
touch the bag to an unpainted metal surface on the computer for
at least two seconds. Make sure to touch a metal surface before
touching the drive, to ground any accumulated static energy.
Remove the drive from the static-protective bag. If you must put
the drive down, place the drive on the static-protective bag.
Step 3. Setting the SCSI ID
Use the jumper block,
.2/
in the back panel illustration on page 2-3,
to set your SCSI ID. To set your jumpers, refer to the following
illustrations. Remove and position jumpers to obtain the ID. If
necessary, use a pair of flat-nose pliers to remove the jumpers. The
following illustration shows the ON and OFF positions for jumpers.
Jumper ON
Jumper OFF
15
16
13
14
11
12
9
10
7
8
5
6
3
4
1
2
Pin 7 Omitted
.1/
SCSI ID area
.2/
Active Terminator Enabled
.3/
Termination Power On
Area
.1/
on the jumper block, above, is where you will set your SCSI
ID. Refer to the following table in order to determine the settings
required:
Pins 5-6
Pins 3-4
Pins 1-2
SCSI ID
Off
Off
Off
0
Off
Off
On
1
Off
On
Off
2
Off
On
On
3
On
Off
Off
4
On
Off
On
5
On
On
Off
6
On
On
On
7
2-4 12/24 GB DDS/3 4 mm Internal Tape Drive
