3
Reflection film installation
Please Note: TE-HUD project
s
the display information on the
car
's windshield
, because the
windshield
is double
pane
,
it
will
cause a
double image on the
windshield
when display
ed
.
If you can see the
display information
clearly
, then there is no need to use the reflection
film. If there is a double image, then please use the reflection film.
First, please put the supplied non-slip mats in front of the dashboard,
and then put the TE-HUD on it.
Second, please stick the reflection film on the
windshield
.
The reflecting film should be
placed
right above the host machine and it
should be able to reflect the whole display screen.
Methods of
placing
the film:
1.
Clean
the place that the film will be
placed
on
with a lint free
towel;
then mist the location with water.
2.
Tear off the back side
(marked
1
)
of reflection film, then
place
it to the
location
.
3.
After you have adjusted the location well, you can use a flat
edge
to
slick the film and squeeze the water out until there
is no bubble or water
in it.
4.
Tear off the front side (marked 2) of the reflection film. If the film
cannot
display the whole information, please adjust the non-slip mat.
The first use of TE-HUD
Start engine and power on TE-HUD, showing the current vehicle voltage
and then
begins
to search ECU state, if the TE-HUD shows speed,
rotating speed, indicating that TE-HUD has been installed successfully.
(After 1 minute, if only display the voltage, please check whether TE-
HUD, OBD interface, and OBD data cable are correct
ly
connect
ed
and
the cable plug is fully seated into the
vehicle OBD interface.
Then restart the engine and TE-HUD will rescan.
)
TE-HUD setting
TE-HUD display information is from ECU,
if
there is a difference
between vehicle dashboard and
TE-HUD
, then you can enter the setup
mode to fine-tune the TE-HUD display value, in order to achiev
e an
exact match.
Summary of Contents for TE-HUD
Page 6: ... ...