Version: 23.01
As of: 01/2023
Page
51
from
119
Step 9:
If required: Insert butt connector
•
Butt connectors are inserted via the TF27 support rail and fixed.
•
The butt connector is either attached using two 4.8x15 mm blind rivets (pre-drilling) or two 5.5x25 mm self drilling
screws.
5.9.5 Trapezoidal support
The trapezoidal support is a combination of the trapezoidal sheet metal mounting listed in 5.9.4 and the AeroFix supports. The
modules can only be installed landscape.
Attention!
The system is not wind tunnel tested and must be verified on site by a structual engineer. A static calculation by IBC not occur.
Step 1:
Fix the TRAPEZOIDAL CLAMP and support profile TF27 at the correct distance
The TRAPEZOIDAL CLAMP and support profiles are mountet as described in 5.9.4. The support profiles must be laid parallel at an
axial distance of module 20 mm.
Figure 77 Insert butt connectors
Figure 78 Joining together the support rails
Figure 79 Gap = Module 20 mm
Summary of Contents for TopFix 200
