BIOS SETUP
MI910 User’s Manual
43
Video Off Method
This field defines the Video Off features. There are three options.
V/H SYNC + Blank
Default setting, blank the screen and turn
off vertical and horizontal scanning.
DPMS
Allows BIOS to control the video display.
Blank Screen
Writes blanks to the video buffer.
Video Off In Suspend
When enabled, the video is off in suspend mode. The default setting is
Yes
.
Suspend Type
The default setting for the Suspend Type field is
Stop Grant
.
Modem Use IRQ
This field sets the IRQ used by the Modem. By default, the setting is
3
.
Suspend Mode
When enabled, and after the set time of system inactivity, all devices
except the CPU will be shut off.
HDD Power Down
When enabled, and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.
Soft-Off by PWRBTN
This field defines the power-off mode when using an ATX power
supply. The
Instant Off
mode allows powering off immediately upon
pressing the power button. In the
Delay 4 Sec
mode, the system powers
off when the power button is pressed for more than four seconds or
enters the suspend mode when pressed for less than 4 seconds.
Wake up by PCI Card
By default, this field is disabled.
Power On by Ring
This field enables or disables the power on of the system through the
modem connected to the serial port or LAN.
Summary of Contents for MI910E
Page 8: ...INTRODUCTION 4 MI910 User s Manual Board Dimensions...
Page 16: ...INSTALLATIONS 12 MI910 User s Manual Connector Locations on MI910E...
Page 17: ...INSTALLATIONS MI910 User s Manual 13 MI910E Solder Side...
Page 30: ...INSTALLATIONS 26 MI910 User s Manual This page is intentionally left blank...