![background image](http://html1.mh-extra.com/html/ibase-technology/mi910e/mi910e_user-manual_3333055043.webp)
BIOS SETUP
MI910 User’s Manual
39
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Device
POWER ON Function
BUTTON ONLY
ITEM HELP
KB Power ON Password
Enter
Hot Key power ON
Ctrl-F1
Onboard Serial Port 1
3F8/IRQ4
Onboard Serial Port 2
2F8/IRQ3
UART Mode Select
Normal
RxD, TxD Active
Hi, Lo
IR Transmission Delay
Disabled
UR2 Duplex Mode
Half
Use IR Pins
IR-Rx2Tx2
PWRON After PWR-Fail
Off
Menu Level >
IDE HDD Block Mode
This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.
On-chip Primary PCI IDE Enabled
This field, by default, is enabled
On-chip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select
Enabled
to activate each channel
separately.
IDE Primary/Secondary Master/Slave PIO
These fields allow your system hard disk controller to work faster.
Rather than have the BIOS issue a series of commands that transfer to or
from the disk drive, PIO (Programmed Input/Output) allows the BIOS to
communicate with the controller and CPU directly.
The system supports five modes, numbered from 0 (default) to 4, which
primarily differ in timing. When Auto is selected, the BIOS will select
the best available mode.
IDE Primary/Secondary Master/Slave UDMA
These fields allow your system to improve disk I/O throughput to
33Mb/sec with the Ultra DMA/33 feature. The options are
Auto
and
Disabled
.
Summary of Contents for MI910E
Page 8: ...INTRODUCTION 4 MI910 User s Manual Board Dimensions...
Page 16: ...INSTALLATIONS 12 MI910 User s Manual Connector Locations on MI910E...
Page 17: ...INSTALLATIONS MI910 User s Manual 13 MI910E Solder Side...
Page 30: ...INSTALLATIONS 26 MI910 User s Manual This page is intentionally left blank...