11
2. Locate the memory card slot on the upper part of the exposed right panel.
3. Insert the memory card into the slot with its gold contacts facing down until it clicks into place.
Note: To remove the memory card, pull it to eject it from the slot.
Charging the Battery
New batteries are shipped partially charged. Before you start using your device, it is
recommended that you charge the battery. Some batteries perform best after several full
charge/discharge cycles.
The battery can be charged and discharged many times, but it will eventually wear out. When the
talk and standby times are noticeably shorter than normal, get the battery replaced. Use only iBall
approved batteries, and recharge your battery only with iBall approved chargers designated for
this device. If a battery is being used for the first time or if the battery has not been used for a
prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it
to begin charging the battery. If the battery is completely discharged, it may take several minutes
before the charging indicator appears on the display or before any calls can be made.
Note:
Only the AC adapter provided with your device must be used to charge the device.
Connect the USB connector of the AC adapter to the sync connector on your device, and then
plug in the AC adapter to an electrical outlet to start charging the battery.
As the battery is being charged while the device is on, a charging icon appears in the title bar of
the Home screen. After the battery has been fully charged, a full battery icon appears on the title
bar of the Home screen.
Warning!
• As a safety precaution, the battery stops charging before it overheats.
3. Starting up the Device
Power ON / OFF
To power OFF your Slide, press & hold the POWER key. On release, the options menu opens.
Select ‗Power off‘ from the given options and confirm. This will turn off the device.
To power ON again, press & hold the POWER key. The iBall power start up animation will appear
on the screen indicating that the device is starting. It takes around 40 seconds to completely
reboot the device.
Silent(No Intruption) mode
To put your device on silent mode quickly, press & hold the
– volume down button to zero
volume. The volume level 0 is the vibration mode.
During volume/down touch ―None‖ option for
no intruption Or on the Home screen, touch and select Settings
Audi
o profiles. Select ‗Silent‘
radio button. You can only activate silent profile but cannot customize it. You can also long press
the power key and you will get the option to change user profile.
Screen tme out
After a period of inactivity, your screen will go to sleep (display will turn black). In sleep, your
Slide uses less battery power. You can control this behaviour by following the below mentioned
steps:
Set screen timeout period
