Manual
ibaMS16xAO-10V/-20mA
10
Issue 1.4
5
System requirements
5.1
Hardware
Central unit: ibaPADU-S-IT-2x16 or ibaPADU-S-CM (version 02.10.001 or later)
Backplane unit, e. g. ibaPADU-B4S
5.2
Software
ibaPDA version 6.34.0 or later
ibaLogic-V5 version 5.0.2 or later
Note
The use of ibaLogic-V5 requires the central unit ibaPADU-S-IT-2x16. If the module is
used with the predecessor ibaPADU-S-IT-16, only ibaLogic-V4 can be used.
6
Mounting, Connecting, Dismounting
Works on the device must NOT be done when it is under voltage! Always disconnect
the central unit from the power supply!
Note
Mount one or more modules on the right next to the central unit (slot X2 to X5 can be
freely selected).
6.1
Mounting
1.
Disconnect the central unit from the power supply.
2.
Remove the cover from the backplane bus, to which the module should be attached.
3.
Attach the device to the backplane bus and press it firmly against the backplane.
4.
Secure the device with the fixing screws.
5.
Connect the grounding screw with the protective ground / grounding shield.
Connect the grounding screw on the bottom side of the housing with the protective ground
/ grounding shield.
Important Note
Always screw tight the device and the modules. If you do not screw it tight, connecting or
disconnecting the connectors for the inputs and outputs might cause damages.
