Manual
ibaBM-DPM-S-64
62
Issue 2.5
12
Configuration
12.1
ibaPDA-V6 I/O Manager
To measure and record data over ibaBM-DPM-S-64, you need ibaPDA-V6, ibaPDA
(v5.xx) or ibaLogic 3 and 4.
In older programs the configuration needs to be done like used with the predecessor
device ibaBM-DPM-64.
For configuration in ibaPDA-
V6 you’ll find a short description as follows.
1.
Select an ibaFOB-D card as data interface.
2.
Add a DPM64 module under this interface. (If the device is turned on and connect-
ed to the ibaPDA-V6, it will normally be detected automatically.) If necessary, per-
form "Automatic detection."
3.
Provided that the device is already configured, the mode of operation will be dis-
played in the general module view. If the device is not configured, select the mode
in the “DPM64” field on the “General” tab.
4.
On the tab “Analog”, column “Name”, enter now the signals one after the other and
the physical units in column Unit, if applicable.
5.
Also enter the values for gain and offset on the” Analog” tab, if applicable.
6.
For the digital signals proceed correspondingly on the tab “Digital” but only the sig-
nal names are required.
