ibaBM-DPM-S-64
Manual
Issue 2.5
47
10.1.2
Network Configuration Data
Clicking the <Network> button in the navigation section takes you to the configuration
data of the network accesses.
You must be logged in
as “admin” in order to change network settings.
Figure 9:
Web interface - Page with network settings
This page shows all network adapters of the device. You can set the IP address
, the
appropriate network subnet mask
and the default gateway
for each adapter. Fur-
thermore, you can select if an existing DHCP server in the network is to be used
.
Click the <Submit> button
to save the entries for the appropriate network adapter.
<Reset entries>
deletes the entries.
The network settings will not take effect until you have restarted the device. The device
can be restarted either by turning it off and then back on or by clicking the <Restart>
button
.
Important note
In case of wrong entries, it may occur that you lose access after restart!
Tip
There is a possibility to reset the network parameters to default values.
For more information see chapter „Switches S1 and S2 “, page 16.
Note
Due to the simple point-to-point connection and the considerable slower establishing of
connection we recommend avoiding the use of DHCP in conjunction with USB.
