MAN-043/B
35
Before assembling the clutch, wash with diluent the shaft taper, the connecting hole on the clutch
body, the clutch drum and the starter ring.
Install clutch
1.
Install the starter ring on the clutch body by matching
the three holes and the dragging pin (3 screws M6).
ATTENTION: make sure to always install the Ø 7
mm dragging pin as otherwise, the eventual kick
backs, could break the screws.
12 point wrench 10 mm
(torque at 10 Nm) (90 in-lb)
(apply “Loctite”on the threads)
2.
Install clutch body and the cone safety washer.
Apply “Loctite 641” for coaxial lockings
3.
Install the clutch body fixing nut and starter ring, using
the clutch wrench.
ATTENTION: turn counterclockwise as nut has
left thread.
Clutch wrench P.N. 10270
12 point wrench 30 mm.
(torque at 100 ÷ 110 Nm) (885 ÷ 970 in-lb)
4.
Install the internal washer.
ATTENTION: install washer with bevel towards
internal part of the engine.
Clean the roller cage and grease it before installing it
on the crankshaft.
5.
Install the clutch drum and the external washer.
ATTENTION: install washer with bevel towards
internal part of the engine.
6.
Install the piston fitting to prevent the shaft from
turning and install the clutch cover (M10 nut) .
Piston fitting : P.N. 10271
17 mm socket
(torque at 30 ÷ 40 Nm) (265 ÷ 350 in-lb)
7.
Install the clutch cover (3 screws M 6).
Allen wrench 5 mm – T type.
(torque at 8 ÷ 10 Nm) (70 ÷ 90 in-lb)
4.3 GEAR TIMING SCHEMATIC
In case of assembly of the gears which drive the balance shaft, assembly must be
performed following the timing schematic shown below.
ATTENTION:
An uncorrect assembly of the gears can cause a malfunction in the vibration
reduction system.
Summary of Contents for Parilla x30 125cc RL-TaG
Page 1: ...MAN 043 B ASSEMBLY INSTRUCTIONS USER MANUAL 20 10 11...
Page 34: ...MAN 043 B 32...
Page 47: ...MAN 043 B 45...
