CV-M77
- 4 -
5. Pin Assignment
5.1. 12-pin Multi-connector (DC-IN/Trigger)
Type: HR10A-10R-12PB-01
(Hirose) male.
Pin no.
Signal
Remarks
1
GND
2
+12 V DC input
3
GND
4
Iris video output
Video for lens iris control. (With comp sync.)
Can only be used in normal continuous mode.
5
GND
6
HD input
/output
SW-S301.1 “ON” for 75
Ω
termination,
SW-S303.1 “OFF” for HD output
7
VD input
/output
SW-S301.2 “ON” for 75
Ω
termination,
SW-S303.2 “OFF” for VD output
8
GND
9
NC
/Pclk out
PCLK out: JP305 “short”, JP306 “open”
Do not output Pclk if not used!
10
GND/NC/
WEN out
NC: JP309 and JP310 “open”.
GND: JP308 “open” JP309 and JP310 “short”
11
Trigger input
/NC/+12V
NC: JP401 and JP301* “open”.
+12V DC JP401 “short” and JP301* “open”
12
GND
(Seen from rear of camera.)
3
4
5
6
7
8
9
10
11
12
1
2
Fig. 2. 12-pin connector.
Notes:
Factory settings in
bold italic
*1) Signals on pin no. 4 and 6 can be changed by jumpers.
See “7. Configuring the Camera” for more information
*2) Do not input ext. VD in trigger modes
*)JP301 is “short” by a capacitor
5.2. 6 pin Multi-connector (RS-232C/Trigger)
Type: HR10A-7R-6PB (Hirose) male.
(Seen from camera rear.)
Fig. 3. 6-pin connector
Pin no.
Signal
Remarks
1
TXD out
RS-232C
2
RXD in
RS-232C
3
GND
4
NC
/GND
GND if JP402 short. *1)
5
Ext. Trig input
6
EEN out
/WEN out
WEN out if JP312 open, JP311 short. *1)
Notes:
Factory settings in
bold italic
*1) Signals on pin no. 4 and 6 can be changed by jumpers.
See “7. Configuring the Camera” for more information.
1
2
3
4
5
6
