36
Drawer Assembly
HARDWARE KIT HWR277
ITEM DESCRIPTION
QTY
A
Bolt, 1/4-20 X .750 SQ Black
4
B
Washer 1/4 Flat Black
12
C
Nut, 1/4-20 Hex Keps Black
8
D
Bolt, 1/4-20 X .750 Hex Head 4
Step: 1
Remove drawer by pulling it out of drawer case enough to locate the two small plastic tabs on the
drawer slides. Push the right tab DOWN and the pull left tab UP and pull the drawer body out of
the drawer slides.
Step: 2
Attach case to the worksurface hat sections by sliding the heads of two1/4-20 X .75 square head
bolts item A into each worksurface hat section. Place the drawer case mounting slots over the
bolts and secure with 1/4 flat washers item B and 1/4-20 hex nuts item C. Slide the drawer case to
the center of the worksurface and hand tighten the hardware only. When the worksurface is
assembled to the workstation frame slide the drawer to the desired location and tighten the
mounting hardware. Install the drawer body at this time.
NOTE:
Although IAC does not recommend customers assemble suspended cabinets to the
worksurface before they are assembled to the workstation frames, if you decide to do this ALL
drawers must be removed from the suspended cabinets before they are assembled to the
worksurfaces. This will make the cabinets lighter and therefore make it easier to turn the
worksurfaces over and assemble them to the workstation frames.
