© 2013 I-View Now, LLC. All Rights Reserved.
Nuvico EasyNet ED-P Series Installation Guide rev 1.0
Page 7
SMTP Settings
This section describes how to set up SMTP (email) on the DVR to allow Alarm notifications to be sent to I-View Now.
Navigate back to the Network Setup Menu
Click Notification
The SMTP id for the DVR is generated upon adding the device
to the dealer portal. Both the receiver address and the sender
address must be set to the auto generated SMTP
id for I-View Now to identify alarms from the DVR.
Enter The SMTP id from the installer’s
worksheet into the
Receiver
address
Enter The SMTP id from the installer’s
worksheet into the
Sender
address
Enter SMTP Server as ivnview.com
Enter Port as 3480
Ensure SSL is
not
checked
Enter nuvico for SMTP id, it cannot be blank
Enter nuvico for password, it cannot be blank
Click Test to verify connectivity to the I-View
Now server. This test does not verify if the
Sender/Receiver has been correctly set. It only
tests email connectivity to the I-View Now
Server.
Click Save to finalize settings
Setup Menu->Advanced tab->Network Menu
Setup Menu->Advanced tab->Network Menu->Notification