8
I-VALO OY
|
TEL +358 (0) 10 501 3000
|
|
WWW.I-VALO.COM
EN
INSTALLATION
•
The luminaire may only be installed by a professional electrician in accordance with local legislation.
•
The luminaire may only be used in an environment for which it has been designed according to its rating label.
•
Always connect the luminaires when there is no incoming voltage.
•
Changing construction of the luminaire and making any changes to cabling is prohibited.
•
I-Valo luminaires are always delivered equipped with mounting holes. Do not make any other holes in the frame.
•
The luminaire can be installed directly to the ceiling or other installation surface from the lugs at the ends of the
luminaire.
•
The luminaire can also be installed with a separately ordered installation fastener according to the installation
location:
- 6021 wire suspension bracket
- 6035 stepless wall bracket (2 pcs)
- 6036 adjustable rail bracket (2 pcs)
- 6060 wall bracket (2 pcs)
- 6061 wall bracket (not compatible with the MA20 luminaire)
- 6063 pole bracket (not compatible with the MA20 luminaire)
- 6065 pipe bracket (not compatible with the MA20 luminaire)
- 6066.030.00 continuously adjustable alignment bar (not compatible with the MA20 luminaire)
- 6079 wire bracket
USAGE & MAINTENANCE
•
Before performing maintenance, power must be disconnected from the luminaire. It takes several minutes for the
luminaire components to cool down.
•
The luminaire must not be used without its cover glass. In case the cover glass gets broken, disconnect the luminaire
immediately from the power supply.
•
The condition of the bracket and sealing surfaces should be checked regularly.
•
In case the luminaire gets damaged in a way that affects the enclosure given in the rating label (IP rating), replace it
immediately! A damaged luminaire must not be used; power must be disconnected from it immediately.
•
An unstable electrical grid may damage the electronic components of the luminaires.
•
Temperature and the quality of the supply voltage affect the service life of the electronic control gear. The estimated
failure rate during the service life of the control gear is no higher than 10%. Transients and voltage spikes significantly
reduce the service life, as does unclean supply voltage, and they may break the control gear.
•
The luminous emittance of LED luminaires has a tolerance of ±10%. The luminous flux of LED light sources decreases
over their service life just like that of traditional light sources. When an old LED luminaire is replaced with a new one,
the difference in luminous emittance may be evident to the naked eye due to the better lighting power of the new
luminaire. The colour temperature of the luminaire may also change.
•
The product is covered by the Waste Electrical and Electronic Equipment Directive 2012/96/EC (WEEE), and must be
properly recycled at the end of its service life.