I:SY E5 ZR F, Translation Of The Original Operating Instructions

Page: 86 / 258

MY23I0a - 42_1.0_29.08.2023
86
Assembly
5 Assembly

Assemble the pedelec in a clean, dry
environment.

The work environment temperature should be
between 15 °C and 25 °C.

The fitting stand used must be approved for a
maximum weight of least 30 kg.
5.1 Unpacking
The packaging material consists mainly of
cardboard and plastic film.

Dispose of the packaging in accordance with
the regulatory requirements (see Section
10 ).

Pedelecs are fully assembled in the factory for
test purposes and then dismantled for
transportation. The pedelec is 95% to 98% pre-
assembled.
Scope of delivery
5.2 Required tools
The following tools are required to assemble the
pedelec:
Risk of eye injury
Problems may arise if components are set
incorrectly. They may cause serious injuries to
the face.
 Always wear safety glasses to protect eyes
when assembling pedelecs.
Crash and crushing hazard caused by
unintentional activation
There is a risk of injury if the electric drive system
is activated unintentionally.

Remove the battery.
WARNING
!
CAUTION
!
 1 × pre-assembled pedelec

1 × front wheel
 2 × pedals

2 × quick releases (optional)
 1 × charger

1 × set of operating instructions on CD
 1 × battery (supplied separately from the pedelec)
Knife
Ring spanners
8 mm, 9 mm, 10 mm, 13 mm, 14 mm and 15 mm
Torque wrench
Working range 5… 40 Nm
by.schulz handlebars:
TORX® bits: T50, T55, and T60
Hex key
2 mm, 2.5 mm, 3 mm, 4 mm, 5 mm, 6 mm and
8 mm
Cross-recess screwdriver
Slotted-head screwdriver
Table 27: Tools required for assembly