17
1. Refer to Fig. 16 to determine Door Bracket (L)
mounting number and locations for your bed size.
Note that the brackets need to point downward when
Attach the Door Panels
installed and that the locations shown are for the
bottom mounting hole on the Door Brackets.
2. Drill 5/64" diameter x 5/8" deep pilot holes at those
locations on your Door Panel(s) (5) and attach each
Door Bracket (L) with two #8 x 15mm Screws (W).
3. Mount your door handle(s)(not included) to the front
face of your Door Panel(s)(5) at a height that will
allow you to comfortably pull down the bed. About
one-third of the way down from the top of the door
is a good rule of thumb.
Fig. 16
6"
6"
10"
27
5
⁄
16
"
27
5
⁄
16
"
Measurements
are for the
placement of
this hole
6"
6"
10"
30
3
⁄
4
"
30
3
⁄
4
"
Twin and Full Bed Door Panel
(2 Panels required for Full Bed)
Queen Bed Door Panel
(2 Panels required for Queen Bed)
L
5
5
>
Do NOT use an impact driver to drive fasteners;
the added torque of an impact driver increases
the risk of stripping the pilot holes and weakening
connections. Do NOT overtighten screws.
Back of
Door Panel
Back of
Door Panel
Summary of Contents for REVISED VERTICAL MURPHY BED
Page 19: ...19 Fig 19 Fig 20 P O Q O P H...
