I-Semble REVISED VERTICAL MURPHY BED, Instructions Manual

Page: 13 / 20

13
Assemble the Bed Frame
All steps in this section use Frame Exploded View.
Frame Exploded View
1. Attach Upper/Lower Half Frame Supports (B) to
one Left/Right Side of the Frame (A), using
M8 x 50mm bolts (BB) and M8 Lock Nuts (FF).
2. Attach a Middle Frame Support (C) to the Left/Right
Side of the Frame (A), using M8 x 50mm bolts (BB)
and M8 Lock Nuts (FF).
3. Repeat Steps 1 and 2 for the other Left/Right
Side of the Frame (A), Upper/Lower Half Frame
Supports (B) and Middle Frame Support (C).
Make sure that the mounting plates of
the Upper/Lower Half Frame Supports (B) are pointing
toward each other. Also make sure that the tabs and
corner braces on the Left/Right Side of the Frame (A)
are at the bottom.
4. Attach a Flat Bar (F) and an Upper/Lower Frame
Support (E) to each end of the Long Center Frame
Support (D), using M8 x 50mm bolts (BB) and M8
Lock Nuts (FF).
5. Position the Long Center Frame Support assembly
between the two side frame assemblies, making sure
that all tabs are at the bottom.
Make sure that the metal tabs
protruding from the Upper/Lower Frame Supports (E)
and the Long Center Frame Support (D) are at
the bottom.
6. Bring the assemblies together, fitting the narrowed
ends of the Upper/Lower Frame Supports (E) into the
open ends of the Left/Right Sides of the Frame (A).
7. Attach the side assemblies to the Long Center
Frame Support (D) with M8 x 50mm bolts (BB) and
M8 Lock Nuts (FF).
8. Complete the frame by installing M8 x 50mm
Bolts (BB) through the Flat Bars (F) and the
Left/Right Sides of the Frame (A) near the corners
and securing with M8 Lock Nuts (FF).
Make sure that the Flat Bars (F) bolted
to the Upper/Lower Frame Supports (E) remain on the
outside of the Left/Right Sides of the Frame (A).
D
A
BB
FF
F
E
F
E
A
B
C
B
B
C
B
BB
BB
BB
BB
FF
FF
FF
FF
FF
FF
FF
FF
FF
FF
34x
34x
BB
BB
BB
BB
BB
BB
Pivot
Point
Pivot
Point