15
Install the Frame in the Cabinet
1. Attach the Pistons (G1) to the bed frame on each side
by fitting the opening on the end with the internal rod
onto the threaded stud beyond the pivot point at the
head of the frame. Secure the Pistons to the frame with
M8 Lock Nuts (FF).
Fig. 10.
2. Install the frame in the Mounting Plates (I) by
positioning the bearing of the pivot point on the
Left/Right Sides of the Frame (A) in the saddle
of each plate.
3. Secure the bearing on each side in place with a Saddle
Locking Plate (J). The tab at the front of the plate fits
into an opening in the saddle, and the plate is secured
to the saddle with an M5 x 15mm Screw (Z) and M5
Nut (EE).
Fig. 11. Tighten the Screw fully.
4. Carefully tilt the frame upward past the front edge of
the cabinet and hold it there.
Fig. 12. On each side,
fit the end of the Piston (G1) onto the threaded stud
on the Mounting Plate (I) and secure with an M8
Lock Nut (FF).
Fig. 13.
Once the pistons are attached to the
Mounting Plates, the unit is under pressure. Do NOT
let go of the mechanism if you have pulled the bed
frame down; the bed frame could snap up suddenly,
possibly causing serious injury.
Fig. 10
Fig. 11
Fig. 13
Fig. 12
Pivot Point
FF
G1
Bed Frame
Frame
pushed
past the
edge of
the cabinet
FF
G1
Z
I
EE
Pivot Point
J
Mounting
Plate Saddle
The application of a thread-locking
liquid to the M5 x 15mm Screw (Z) is recommended to
ensure the M5 Nut (EE) remains securely tightened.
>
To avoid the risk of serious injury, Do NOT unscrew
the bed cabinet from the wall once the pistons are
in place.
Summary of Contents for REVISED VERTICAL MURPHY BED
Page 19: ...19 Fig 19 Fig 20 P O Q O P H...
