Step 2 : Installed and connected controller ,and make sure controller under on state
(after controller connect battery ,the controller will automatic start )
Step 3:Connect PC and controller with RS232 ,make sure they had been connect ,PC
will notice com ,at this time the PC will chose COM1 :
Step 4:Open Solar Eagle ( WIN 7
，
WIN 8 system ,please open as
administrator ) ,then press
to chose COM communication and enter ,it will
automatic connect :
Step 5 : After all these steps ,the information could be check on Solar Eagle .If need to
set special parameters ,please ask our company to accredit .
2) Customer do not have PC connector .
If customer do not have RS232 connector , then customer need to prepare a USB
to RS232 connector like the following picture :
Step 1: Please install USB to RS232 driver software and make sure it had been
connect with RS232 . The other step is same as above .
8.2.2 Connect through LAN ( TCP/IP )
1)Connect through RJ45 ,like the following picture
