Step 1 : Please install Solar Eagle ,details please kindly check install steps .
Step 2 : Installed and connected controller ,and make sure controller under on state
(after controller connect battery ,the controller will automatic start )
Step 3: Connect PC and controller through RJ45 .
Step 4:
First way
:Based on PC GATED ADDRESS and IP ADDRESS to set the
controller’s PC GATED ADDRESS and IP ADDRESS . But please note the last
number of IP address should keep different .Like : PC’s PC GATED ADDRESS is
192.168.1.1 ,IP ADDRESS is 192.168.1.10 , then set of controller is GATED
ADDRESS is 192.168.1.1 ,IP ADDRESS is 192.168.1.8 : Make sure controller and
PC in the same LAN .
Second way :
Based on PC GATED ADDRESS and IP ADDRESS to set the
controller’s PC GATED ADDRESS and IP ADDRESS . But please note the last
number of IP address should keep different .Like : Controller’s GATED ADDRESS is
192.168.1.1 ,IP ADDRESS is 192.168.1.10 , then set of PC’s GATED ADDRESS is
192.168.1.1 ,IP ADDRESS is 192.168.1.8 : Make sure controller and PC in the same
LAN .
Step 5: Open Solar Eagle ( WIN 7 ,WIN 8 system ,please open as
administrator ) ,then press
to chose TCP/IP communication and fill IP address
and port number ,enter ; It will automatic connect in 10s : If could not connect , please
make sure controller and PC in the same LAN and restart controller .
1
）
Connect through router as following picture ;
Step 1 : Please install Solar Eagle ,details please kindly check install steps .
Step 2 : Installed and connected controller ,and make sure controller under on state
(after controller connect battery ,the controller will automatic start )
Step 3: Connect controller and router through RJ45 .Then add PC into LAN.
Step4: Set controller and PC’s GARE ADRESS based on router’s GATE
ADRESS .Keep them in the same LAN . Like : router’s GATE ADRESS is
