MagicSurfer 56K
User’s Guide
Page 28
%N0
%N1
%N2
%N3
%N4
%N5
%N6
%N7
%N8
%N9
Dynamic CPU loading disabled
Dynamic CPU loading not to exceed 10%
Dynamic CPU loading not to exceed 20%
Dynamic CPU loading not to exceed 30%
Dynamic CPU loading not to exceed 40%
Dynamic CPU loading not to exceed 50%
Dynamic CPU loading not to exceed 60%
Dynamic CPU loading not to exceed 70%
Dynamic CPU loading not to exceed 80%
Dynamic CPU loading not to exceed 90%
%Q
Report line signal quality
\ Backslash
Commands
\A0
64-character max. MNP block size
\A1
128-character max. MNP block size
\A2
192-character max. MNP block size
\A3
256-character max. MNP block size
\Bn
In non-error correction mode, transmit break in 100 ms units (1-9 with
default 3)
\G0
Disable XON/XOFF flow control (modem to modem)
\G1
Enable XON/XOFF flow control (modem to modem)
\Kn
Define break type (refer to table 2)
\L0
Use stream mode for MNP
\L1
Use interactive block mode for MNP
\N0
Normal mode; speed control without error correction
\N1
Plain mode; no speed control and no error correction
\N2 Reliable
mode
\N3 Auto-reliable
mode
\N4
LAPM error correction only
\N5
MNP error correction only
*
Asterisk commands
*Q0
*Q1
Send the “CONNECT xxxx” result codes to the DTE when an
invalid TIES escape sequence is detected after the OK”
response
has already been sent
Does NOT send the “CONNECT xxxx” result codes to the DTE when
an invalid TIES escape sequence is detected after the OK” response
has already been sent
S Registers
REG.
Function
