home
home
19
I N T E R A C T I V E U S E R G U I D E
General issues
•
Check that the wall socket is supplying power. Then the
LED on the receiver’s power plug should light up green.
•
Check if the power cable, SCART cable, and antenna
cable are correctly connected and that the receiver is
switched on. Try disconnecting and then reconnecting
these cables to ensure they are properly in place.
•
Your receiver is in standby mode, so just press the
button on your remote control to take it into full
operational mode.
•
Make sure your receiver is in operate mode.
•
Make sure that you are pointing your remote control
at the receiver’s front panel.
•
Check the batteries in your remote control.
•
Make sure that the receiver is not exposed to
direct sunlight.
•
If these measures do not work the problem may be
caused by a temporary transmission error, or some of
your receiver’s software settings may have been lost.
Try switching off your receiver at the power source and
switch it back on after a few seconds.
- The standby indicator on
the receiver’s front panel
does not light up.
- The standby indicator on
the receiver’s front panel
is red.
- Your remote control fails to
operate your receiver.
Symptom
Solution
Installation issues
•
If you are using a directional antenna, make sure it
is pointing towards a digital TV transmitter and
positioned correctly.
•
Make sure that it is possible to receive digital terrestrial
signals in your area.
•
We recommend you use a standard outdoor antenna,
which normally works better than an indoor one.
•
Check that the antenna cable is connected correctly.
•
If these steps do not resolve the problem, you should
call your vendor.
- You cannot fi nd channels.
Symptom
Solution
TROUBLESHOOTING
