I-Bus IBC 2600, User Manual

Page: 116 / 140

Appendix 1 - BIOS Messages
A1-12
IBC 2600 User’s Guide
PORT 80 CODES (continued)
Code Description
84 Locked key checking over. Checking for memory size mismatch with
CMOS RAM data next.
85 Memory size check done. Displaying soft error and checking for
password or bypassing Setup next.
86 Password checked. Performing any required programming before
Setup next.
87 Programming before Setup complete. Uncompressing Setup code and
executing Setup utility next.
88 Returned from Setup program and screen is cleared. Performing any
necessary programming after Setup next.
89 Programming after Setup complete. Displaying power-on screen
message next.
8B First screen message displayed. “Wait . . .” message displayed.
Performing PS/2 mouse check and extended BIOS data area
allocation check next.
8C Programming Setup options next.
8D Setup options are programmed. Resetting hard disk controller next.
8F Hard disk controller reset done. Configuring floppy drive controller
next.
91 Floppy drive controller configured. Configuring hard disk drive
controller next.
95 Initializing bus option ROM’s from C800 next. (See end of Port 80H
Codes for details of different buses.)
96 Initializing before passing control to adapter ROM at C800.
97 Initialization before C800 adapter ROM gains control completed,
Adapter ROM check next.
98 Adapter ROM had control and has returned control to BIOS POST.
Performing any required processing after option ROM returned
control.
99 Any initialization required after option ROM test has completed.
Configuring timer data area and printer base address next.
9A Set timer and printer base addresses. Setting RS-232 base address
next.
9B Returned after setting RS-232 base address. Performing any required
initialization before coprocessor test next.