Chapter 3 - Hardware
0818D User’s Guide
3-5
3. Completely retract the injector/ejector handles by pressing them
away from each other.
Note: This may require some force.
4. Slide the rear I/O module out of the chassis.
Note: If you do not plan on immediately replacing a removed
I/O module, you must close the space left open with a filler panel
in order to maintain EMI specifications.
3.3.2 Insertion of a Rear I/O Transition Module
1. With the Injector/Ejector handles in their outward (open) position,
insert the rear I/O module on its card guides until the handle
latches begin to engage. Make sure the two guide pins mate
properly into the corresponding hole in the rear I/O card guides.
2. Engage the injector/ejector handles by pressing them towards
each other.
Note: If a firm steady pressure on the handles does not readily
seat the board, verify proper board alignment, clear insertion
path and connector pin straightness.
3. Secure the rear I/O board module by tightening the two captive
screws (if they are present).
4. Turn on the main system power.
Summary of Contents for 0818D
