FEATURES OF YOUR HYUNDAI
1- 32
B260C01O-GAT
Traction Control Indicator
Lights(If installed)
The traction control indicators change opera-
tion according to the ignition switch position
and whether or not the system is in operation.
They will also illuminate when the ignition key
is turned to the "ON" position, but should go
out after the engine starts. If the TCS indicator
blinks or stays on, take your car to your
authorized Hyundai dealer and have the sys-
tem checked. See section 2 for more informa-
tion about the TCS system.
B270A01A-AAT
BRAKE PAD WEAR WARNING SOUND
The front disc brake pads have wear indica-
tors that should make a high-pitched squeal-
ing or scraping noise when new pads are
needed. The sound may come and go or be
heard all the time when the vehicle is moving.
It may also be heard when the brake pedal is
pushed down firmly. Excessive rotor damage
will result if the worn pads are not replaced.
See your Hyundai dealer immediately.
B290A01A-AAT
ENGINE COOLANT TEMPERATURE
GAUGE
B290A01O
"ON" or come on while driving, there may
be a problem with E.B.D (Electronic Brake
Force Distribution).
If this occurs, avoid sudden stops and
have your vehicle checked by your Hyundai
dealer as soon as possible.
B270B01O-AAT
PARKING START WARNING SOUND
If the vehicle driven at over 2mph(3km/h)
more 2~3 seconds, the warning chime will
sound continuously when the parking brake
engaged.
The needle on the gauge indicates the ap-
proximate fuel level in the fuel tank. The fuel
capacity is given in Section 9.
B280A01A-AAT
FUEL GAUGE
B280A01O
WARNING:
Never remove the radiator cap when the
engine is hot. The engine coolant is under
pressure and could erupt and cause se-
vere burns. Wait until the engine is cool
before adding coolant to the reservoir.
The needle on the engine coolant tempera-
ture gauge should stay in the normal range. If
it moves across the dial to "H" (Hot), pull over
and stop as soon as possible and turn off the
engine. Then open the hood and check the
coolant reservoir level and the water pump
B260Q03O-DAT
Cruise Indicator
(If installed)
The cruise indicator light in the instrument
cluster is illuminated when the cruise control
ON
´
OFF switch is pushed on the steering
wheel.
The indicator light does not illuminate when
the cruise control ON
´
OFF switch is pushed
again. Information about the use of cruise
control is beginning on page 1-51.
