FEATURES OF YOUR HYUNDAI
1- 19
B230F01A-AAT
Installation on Rear Seat Center Posi-
tion
Use the center seat belt for the rear seat to
secure the child restraint system as illus-
trated. After installation of the child restraint
system, rock the child seat back and forth,
and side to side to ensure that it is properly
secured by the seat belt.
If the child seat moves, readjust the length of
the seat belt. Then, if equipped, insert the
child restraint tether strap hook into the child
restraint hook holder and tighten to secure the
seat. Always refer to the child restraint system
manufacturer's recommendation before install-
ing the child restraint system in your vehicle.
B230F01A
On center rear seat
Three child restraint hook holders are located
on the rear luggage compartment floor. To
install the child restraint seat, connect the
child restraint tether strap hook to the child
restraint hook holder and tighten to secure the
seat.
Rear luggage compartment floor
B230B01O-1
Anchorage
Front of Vehicle
Tether
Strap Hook
To install a child restraint system in the out-
board rear seats, extend the shoulder/lap belt
entirely from its retractor until a "click" is felt.
This will engage the seat belt retractor auto-
matic locking feature, which allows the seat
belt to retract but not extend. Install the child
restraint system, buckle the seat belt and
allow the seat belt to take up any slack. Make
sure that the lap portion of the belt is tight
around the child restraint system and the
shoulder portion of the belt is positioned so
that it can not interfere with the child's head or
neck. Also, double check to be sure that the
retractor has engaged the Automatic Locking
feature by trying to extend webbing out of the
retractor. If the retractor is in the Automatic
Locking mode, the belt will be locked. After
installation of the child restraint system, try to
move it in all directions to be sure the child
B230G01O-AAT
Installation on Outboard Rear Seats
B230G01L