HYUNDAI
12
MIG
-160/200
Malfunction
Cause and Solution
Welding current is unstable.
1. Check the pressure arm on the wire feeder for proper pressure.
2. Check if the drive roll matches the wire size being used.
3. Check the contact tip of the welding torch for wear. Replace it and
tighten it if necessary.
4. Check the welding wire for good quality.
5. Check if the torch cable is too twisted.
6. Check if the quick plug is loose.
Weld bead is not well protected.
1. Do not move the welding torch away immediately when stopping weld-
ing, so that the shielded gas can protect the weld bead.
2. Prolong the post-flow time of the shield gas, and contact our company.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use
the return and collection systems or contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
Summary of Contents for HYMIG-200
Page 7: ...HYUNDAI 05 MIG 160 200 4 Electric Block Diagram...
Page 16: ......