7.7. Engine running erratically.
7.7.1. If engine is running erratically and is unsatisfactory even though the air filter is
clean and the carburettor properly adjusted, the cause may be in the exhaust.
7.7.2. Have the exhaust checked for contamination (coking) by dealer.
7.8. Replacing the starter rope and rewind spring.
7.8.1. Remove the screws (1).
7.8.2. Take the starter cover(2) off the engine.
7.8.3. Remove the spring clip (3).
7.8.4. Remove the rope rotor with washer (4) and pawl (5). Ease the cap (6) out of
the starter grip.
7.8.5. Remove remaining rope from the rotor and grip.
7.8.6. Tie a simple overhand knot in the end of the new starter rope and then thread
the rope through the top of the grip and the rope bush (7).
7.8.7. Refit the cap in the grip.
7.8.8. Thread the rope through the rotor and secure it in the rotor with a simple
overhand knot
7.8.9. Fit the pawl (5) in the rotor and slip the washer (4) over the starter post.
7.8.10. Use a screwdriver or suitable pliers to install the spring clip (3) on starter post
and over the peg on the pawl-the spring clip must point clockwise - see illustration.
Go to "Tensioning rewind spring".
7.9. Replacing a broken rewind spring.
7.9.1. Lubricate the new spring with a few drops of non-resinous oil.
7.9.2. Remove the rope rotor as described in "Replacing the starter rope".
7.9.3. Remove parts of old spring.
7.9.4. Fit new spring housing - bottom plate must face downward. Engage outer
spring loop over the lug.
7.9.5. Refit the rope rotor.
7.9.6. Go to "Tensioning rewind spring".
7.9.7. lf the spring pops out and uncoils during installation: Refit it in the spring
housing in the counter- clockwise direction - start outside and work inward
Page 17
Rev 2
Summary of Contents for HYB60
Page 1: ...LEAF BLOWER Model HYB60 User Manual...
Page 2: ...Page 2 Rev 2...
