Hyundai HY3810, Instruction Manual

Page: 11 / 20

the tip of the sword and allows better control of the chainsaw in
unexpected situations.
·
Always use replacement bars and chains recommended by the
manufacturer. The wrong replacement bar and the chain can lead to
a chain breakage and / or kickback.
·
Follow the manufacturer's instructions for sharpening and
maintaining the chain. If the depth limiter is set too low, this will
increase the possibility of kickback.
·
Never cut it with the tip of the bar.
·
Make sure that there are no nails or metal parts in the sawing area,
and in particular watch the nails or the iron pieces around the
sawing area. Also be careful when cutting hardwood in which the
chain can get stuck. This can result in kickback.
·
Start the cut at full power and keep the chainsaw at the highest
speed during sawing.
·
Be extremely careful when inserting a chainsaw chain into a
previously created cut.
·
Do not saw branches or parts of wood where change of position
may occur during sawing or where the cut may close during sawing.
·
Designated use
The gasoline chainsaw is intended for sawing thin wood outdoors and is
not suitable for professional use.
Use the product only with original accessories and only as described in
these operating instructions. Any other use is considered inappropriate
and can result in material damage or even physical injury.
Device parts
1. Front arm guard 8. On/Off switch
2. Ignition handle 9. Fuel tank cap
3. Air filter cover 10. Chain oil tank cap
4. Choke 11. Front handle
5. Lock for throttle button 12. Chain
6. Rear handle 13. Guide bar of the chain
7. Throttle button 14. Cover of the noise / clutch silencer
15. Toothed support
Explanation of symbols
A. Warning
B. Read the instructions for use