![background image](http://html1.mh-extra.com/html/hyundai/hhc2g/hhc2g_user-manual_2195017013.webp)
13
HHC4G User Manual
SECTION 6 - START-UP & OPERATION
INITIAL INSPECTION
All air compressors have been inspected carefully before leaving the factory. It
is possible that poor handling during transport caused some damage to the
compressor. Fully inspect the compressor before use.
1.
Inspect the entire unit for any concealed and/or visible damage.
2.
Make sure any damaged parts are replaced and any mechanical is-
sues are repaired by a qualified and licensed/certified mechanic.
PRE-START CHECKLIST
1.
Make sure that the ON/OFF switch is in the OFF position.
2.
Make sure that the tank is fully drained.
3.
Make sure that the tank pressure gauge reads 0 PSI.
4.
Make sure that the drain valves are closed.
5.
Make sure that all covers and safety guards are properly installed and
in place.
INITIAL BREAK-IN PROCEDURE
The following instructions should be followed before the first time the compres-
sor is operated in order to optimize the life of the compressor and to help
prevent any damage to the unit.
1.
Make sure the regulator knob is turned fully counter-clockwise.
2.
Plug the power cord into a properly grounded power outlet.
3.
Open the drain valve in order to allow air to escape and prevent pres-
sure from building up inside the tank.
4.
Turn the ON/OFF switch to the ON position.
5.
Allow the compressor to run for approximately 15 minutes.
6.
Close the drain valve, allowing pressure to build to the cut-out pres-
sure. The compressor will shut off automatically.
7.
Use the compressed air in the tank with an approved attachment or
allow it to bleed out.
START-UP
1.
Make sure the regulator knob is turned fully counter-clockwise.
2.
Plug the power cord into a properly grounded power outlet.
3.
Turn the ON/OFF switch to the ON position.
4.
Allow the compressor to reach the cut-out pressure. The compressor
Summary of Contents for HHC2G
Page 1: ......
Page 2: ...HHC4GAC_UG_EN_0214 2014 MIDLAND POWER INC...
Page 23: ...23 HHC4G User Manual...