Hyundai HDBT52-A, Original Instructions Manual

Page: 4 / 23

4
 Keep the work area clear. Before working, inspect the work area and remove any materials or objects
that could cause accidents.
 Do not force the tool.
 Use only accessories and guards supplied or recommended by the manufacturer. The use of
non-recommended accessories (e.g. metal multi-piece pivoting chains and flail blades) may result an
accident. Ask your dealer for advice.
 Keep firm footing and balance during operation. Always use the harness provided.
 Have a correct working posture; stay stand, do not lean. The working positions should be changed
regularly.
 Always inspect the machine before and after operation. If the tool is damaged or faulty, stop using the
tool and bring it to an authorized service for inspection and repair.
 Be concentrated when using the tool. Look at what you do, make sense and do not use the tool when
you are tired.
 Remove the blade guard before using the tool.
 A damaged part must be properly repaired or replaced by an authorized service center, unless otherwise
specified in this instruction manual.
 Do not use the tool if the switch is not working (if it cannot be turned ON or OFF).
 Immediately stop the tool in the event of a malfunction of the motor or in case of unusual noise.
 Do not use the tool if the starter is damaged.
 Avoid any contact with the cutting attachment during operation; they can cause severe cuts.
 When not in use, the machine must be stored in a dry, locked place out of the reach of children.
 Before using the tool and after any impact, please check for signs of wear or if it is not damaged. If
repairs are required, they should be done by a qualified service.
 Always switch off the machine:
o
Every time you leave it unattended;
o
Before inspection and maintenance
o after hitting a foreign object;
o When abnormal vibration occurs;
o During the replacement of parts.
 Do not use the product on a slippery surface.
 Do not use the product on steep, slippery slopes.
 When planning your work schedule, allow enough time for rest. Limit continuous use of the tool. For
example, do 30 ~ 40 minute sessions interspersed with a 10 ~ 20 minute break. Work a maximum of two
hours a day.
 If the machine has struck foreign objects, check if the tool is damaged and bring it to repair if necessary.
 Keep handles dry, clean and free of oil and grease. Oily, greasy grips are slippery and cause loss of
control.
 Be careful when using the machine during stormy weather. Do not use the machine during lightning and
thunderstorms.
 Warning - When operating the tool, be careful of the emission of exhaust gases, avoid to be exposed to
these and wear protective equipment.