![background image](http://html1.mh-extra.com/html/hyundai/hdbt52-a/hdbt52-a_original-instructions-manual_2197462014.webp)
5. OPERATION
a. Starting the operation
Cold starting
-
Switch on the tool by putting the Start/stop button on the position I (ON).
-
Push the primer bulb 5-7 times, until fuel comes into the primer bulb.
-
Pull the choke lever to the OFF position.
-
Pull the starter cord until the engine starts.
-
Pull the choke lever to the ON position.
-
Allow engine to warm up for a few minutes before using.
-
Push the safety switch then the throttle trigger to start the operation
Warm starting
The warm starting can be done when the tool was switched off but still hot.
-
Switch on the tool by putting the Start/stop button on the position I (ON).
-
Push the primer bulb 5-7 times, until fuel comes into the primer bulb.
-
The choke lever must be kept in the ON position. If it is not the case, restart the machine by performing a cold
starting.
-
Pull the starter cord until the engine starts.
-
Allow engine to warm up for a few minutes before using.
-
Push the safety switch then the throttle trigger to start the operation
b. Stopping the operation
Release the throttle trigger.
Let the tool to rum a few minutes.
Switch off the tool by putting the Start/stop switch on the position O (OFF).
Summary of Contents for HDBT52-A
Page 1: ...1 ORIGINAL INSTRUCTIONS Read carefully this manual before any use...
Page 8: ...8 2 PRODUCT DESCRIPTION...
Page 23: ......