Universal Park Distance Aid System Installation Instructions issue 1.0 – 01/12/03
When installing on particularly wide vehicles do not
exceed the recommended maximum overall width of
1600mm from each outer sensor eye.
Diagram 1.
When installing on particularly narrow vehicles do not
go below the critical minimum overall width of 900mm
from each outer sensor eye.
Diagram 2.
Always observe the recommended (ideal) sensor
locations points as indicated in diagram 3A. Try to
maintain a straight horizontal line across the bumper.
Example
Diagram 3.
The sensors ideally should be mounted between
450mm & 550mm from the ground.
Diagram 4.
The outer sensors ideally should be mounted at least
150mm from the extreme edge of the vehicle.
Diagram 5.
If the sensor eyes require staggering due to mouldings
within the bumper or number plates, spare wheels etc,
do not exceed a 100mm drop or rise.
Diagram 6.
Should the inner sensor eyes require a wider width than
the outer sensor eyes due to number plates etc, do not
exceed a gap of 700mm between the 2 inner sensors
2 & 3. As a result of the wide inner width, try to maintain
a gap of (Ideally) of 300mm or up to 450mm between
sensors 1 &2 / 2 & 3
Document Part No: - MKHYUUNI1203
2
550mm
450mm
100mm
1/8
1/4
1/4
1/4
1/8
1/2
1/2
150mm
300mm
Minimum
300mm
Minimum
700mm
Maximum
Maximum Overall Width
1600mm
Minimum Overall Width
900mm
194
388
388
388
194
776
776
1552mm
Overall Width
A
B