Caution
• Never cover a wet vehicle
• Not liable for repainted surfaces
or lacquer paint
• Do not cover the tail pipe or exhaust
• A hot exhaust and muffler can burn
you and melt your cover
• Be sure the hood and engine are
cool before you put on your cover
• Never cover a convertible with the
top down
• Do not spread cover across an open
sunroof or T-roof
This cover is designed to be water
repellent but it will not prevent water
from reaching the surface of your
vehicle.
Installation
Remove or retract your antenna. See
below if you have a fixed antenna.
Pull your cover over the roof of your
vehicle from the back to the front. Drop
your cover over the sides, then fit the
elastic hem of your cover under the front
bumper of your vehicle. Secure your
cover under the rear bumper and corners.
To secure your cover on your vehicle,
attach one end of the supplied rope to
a grommet (car)/web loop (SUV) set in
the side of your cover. Toss the rope
under the vehicle and tie the rope to
the web loops on the opposite side.
For extra security you may also use a
cable lock in these web loops (cable
lock not supplied).
Antennas
Check your antenna—many antennas
simply unscrew at their base. If
your antenna cannot be removed or
retracted, you will need to make a
small hole in your cover for it.
Put your cover on as much of your
vehicle as you can without covering
the antenna. Mark the area where
your cover will go over the antenna.
With a sharp pencil or pen, carefully
push a small hole in your cover. Peel
the backing from your antenna patch
(Fig.
1
, supplied) and, centering the
hole in the patch over the hole in your
cover, adhere the patch to the outside
of your cover. Press the patch down
firmly. Carefully lift your cover down
over your antenna, threading your
antenna through the hole, and finish
fitting your cover.
Care
Clean your cover with a soft brush
and lukewarm water or machine wash
in COLD water. DO NOT USE SOAP as
it may remove the protective coating
added by the factory. Line dry only; do
not machine dry.
Avoid trapping moisture under your
cover. If your vehicle is outside for
long periods or under snow, trapped
moisture can sometimes cause paint
to become cloudy. We recommend
removing your cover every 30 days.
Let your vehicle dry completely before
reinstalling your cover.
Driver’s Side Door
A handy zippered access door on the
driver’s side allows you to enter your
vehicle without removing the cover.
Storage
A convenient storage bag is provided
for your cover. Be sure the cover is
completely dry before you store it in the
storage bag for an extended period.
Instructions:
PolyPRO
™
3
Car Cover, PolyPRO
™
3
SUV/Pickup Cover
Classic Accessories, Inc.
Kent, WA USA
98032
www.classicaccessories.com
©
2010
09
cC
52
_
10944
10
-
016
-
024001
-
00
,
10
-
013
-
251001
-
00
,
10
-
014
-
261001
-
00
,
10
-
018
-
241001
-
00
,
10
-
019
-
261001
-
00
Fig.
1
